Some of the main causes of the car broke down and deal with it

Hopefully after reading about some of the ways the main cause of the car crash, you don't feel it because you already anticipate, so your journey smoothly Freeway.

Here there are some of the main causes of the car crash that is drawn from a variety of sources, it should be noted below, do not let happen and your car broke down in the way, among them:

1. Electric current weak battery

A weak battery electrical current could be due to several things, namely because the wires in the terminal plus or minus the battery, alternator or dynamo sagging amperage that aus, as well as the battery life had expired.

If you suspect that the battery problem, then steps must first detect You do is check the wiring in the terminal of battery. Make sure the cable has been installed are good or not.

When it turns out the slack, then soon tighten. Earlier, the wipe the terminal used to be using sandpaper or paper (if you bring a toothbrush) to clean the brush.

Don't forget to check the battery water whether volume enough. Immediately add if less than a rate.

However, if the battery is already worn out because life has run out, then inevitably you must replace.

2. Electric current to the coil terminals plus down

The main cause and often occur on a car that has aged five years and over voltage electric current is to coil the drastic slump. As a result, the combustion process does not occur because the cigarette lighters (ignition) is not getting power.

How to detect this problem quite easily, that is, check the cable distributor and paste into the body of the car then a starter car. If there is a spark, it means that an electric current is still there. So any otherwise.

When there is no electricity then check cable connections to make sure if there are any wires that are not connected properly. If the connection cable is apparently not troubled or Platinum coil means damaged or dirty.


3. worn out Alternator

This device serves to charge the electric current to the battery. Therefore, when the alternator is damaged then the backup will run out of battery power and lead to a car crash.

Some of the problems that often occur in the alternator are:

a. disconnect copper wire Windings

Some of the damage that often occurs in this device, among others, the commercial rolls of copper wire. Even though it is only one among several rolls, it would disrupt the flow of electricity.


b. disconnect Diode

Usually there are six diode in the alternator. Although only one diode problem, it is enough to make the car's engine is difficult once ignited.

c. rusty Cable

Electric charging cable from the alternator to the battery are very susceptible to decay. Understandably, the position of the alternator that is on the bottom of the machine is very prone to be exposed to dirt and water, consequently cables become brittle or corrosion.

When that happens, then the battery power to the maximum and not any potential car crash.


4. Carburetor is problematic

The cause of the car crash more often experienced by users of the car is the carburetor problem (for cars still use Carburetors). In General, the problem is the fuel bursts of too little. The result the combustion process is not perfect and difficult machine turned on.


How to detect the problem was fairly easy. The fuel hose off then input its end into the bottle. Then a starter car. When the fuel still flows, meaning fuel is still functioning well, and vice versa.


5. Switcher starter aus

Device: it does seem trivial and often are not realized by the user or the owner of the car. In fact, the likelihood of the occurrence of the damage to these devices is huge. Understandably, most often used switcher that is in the car when the user starts to turn on or off the vehicle engine.

In General, damage occurred on the rift, the metal cable kontaktor plus minus to connect electricity already worn out so that it doesn't connect. When you experience it soon.

But when you experience it in the way that is quiet and away from the crowds, then the emergency step is to connect the cable plus and minus the starter. Do I use a PIN or a small sharp wire, then connect the two cables with a PIN or small wire.